Platforming

TurnTable
Rotating Platform
Caster Corners & Plates
Platforms I
Platforms II
Platforms III
Platforms IV
Platforms V
Platforms VI

TurnTable
Rotating Platform
Castor Corners & Plates
Platforms I
Platforms II
Platforms III
Platforms IV
Platforms V
Platforms VI

Here's a mix-n-match set of platform methods. The open framed part is called a parallel. The platforms on the top are comprised of a basic 4x8 and a 4x4 platform framed using 1x6 lumber. The bottom platforms are only slightly different as they are framed with 2x6 lumber. These bottom platforms also have casters attached.
For more details about how to build these types of platforms, see the articles via the links on the left. The articles are by Michael Powers. I've added some photos of our actual platforms.

Remember the question that was asked during class. How do we make this 4'x4' platform rotate? It is sitting on top of the two 4'x8' platforms that do not provide a solid, complete surface.

To see a larger version, click on the board.

In other words, where do the wheels go?

More questions to think about:

	What is the elevation of each level of platforming?
	What is the height of the caster we're using?
	Do we use straight or swivel casters?
	How do we get the platform to rotate and not go where ever it wants to?
	How do we stop it from rotating? (Lock it in place)
	How do we get it to turn?

This is what the full stage looks like.

A curved platform is pretty easy to build. The curved front is cut from a single piece of plywood. the framing members were cut from the scrap that was created. The front is covered with a thin plywood that is bent, gently. The top was then covered with a sheet of ply and the front edge was trimmed.

Click on the photos to see it much larger.

Hit Counter

Site Home Page [ Back ] [ Up ] [ Next ]

This site is owned & operated by HSTech.org & Scott C. Parker
For information &/or comments, please drop us a line. Webmaster
© 1998-2004. Refer to the Credit Page for additional contributors.